|
The lugano LED spot (1) is available in anodized aluminium or stainless steel. Because of it's wide 90° light angle it's the ideal lighting solution for kitchens and toilets. The spot can be used to light a worktop at only 50 cm distance or an floor area of 4-9 m2 at 2,5 meters distance.
The lugano LED spot can be used to replace standard 50 mm halogen spots.
Mounting the Lugano LED spot
Next to placing the Lugano LED spot directly into a overhanging cabinet (2) or ceiling the Lugano spot can also combined with the Triangle casing (3), the water resistant shower spot housing and ground spot housing as well.
The Triangle casing (3) is an armature which transforms the Lugano LED spot into a surface mounted spot. The Triangle casing (3) can be mounted e.g. below a kitchen cabinet by using the included screws (4). The Lugano LED spot simply snaps into the triangle casing.
The Lugano spot (1) can also be used in combination with the Luzern LED plates (5).
Power supply and electrical connections
The Lugano LED spots are powered by Lumotech® drivers. All Lumotech® drivers can be applied in combination with the Lugano LED spots.
Dimming is always performed with an external dimmer. Please refer to the Dimmerlist for suitable - mains - dimmers.
'Click & Go' connection
The 'Click & Go' cable system provides an easy and modular connection of the LED spots to a driver.
The following drivers are equipped for the 'Click and Go' system:
- L05020NS - Non dimmable.
- L05021NS - Mains dimmable.
- L05011iNS - Pulse dimmable.
- L05016iNS - Pulse dimmable.
The cables with an splitter block are available in standard lengths of 1 metre (2-way splitter) and 2 meters (4-way splitter) and there are extension cables available with lengths of 3, 5, 7 and 10 metres.
At maximum power load the total (secondary) length of the cable should not exceed 10 metres.
A variety of configurations can be found in the following PDF:
 Connectionsceme_LUMOluce.pdf
|
